All the parts where primed using Vallejo light grey primer and after that sprayed with Vallejo (Air color) white.
Windows and doors are sprayed with Vallejo red. After letting it dry for at least whole day subassemblies were put together.
Interior was partialy built. Garage has interior beams and bracing since it can be seen through open door. Office has just some simple furniture which can be seen through windows (and door).
Garage interior is hand painted tan color then given brown wash to tone everything down.
Both office and garage got some period posters. Office also has a styrene floor with scribed and painted simulated wooden floor. There is styrene built table and printed out shelf in office (printed since it is not clearly seen from outside).
Garage has styrene shelf, some machines and tool table all of which will be placed later since garage has no floor and everything will go on floor glued to module.
Trim was done using 1×4 strips of styrene painted red. After gluing it to the building everything is touched up with brush and red color.
Roof was intended to be made as tar paper covered one. “Subroofing” was made out of cardboard and some bracing holding it together. It will be removable for later addition of interior lights. After glue has set roof is covered with masking tape cut to the width of paper strips and glued to cardboard with overlaps. Ridge was made with one longer strip of tape.
Masking tapa was painted with Vallejo German grey (my choice for “almost black and little sun faded) and light grey dry brush.
There still remain some weathering, lights, chimney and installation on module.